# Keeping Concrete in Shape Through Missouri Seasons

> Concrete maintenance in Missouri: sealing, de-icers, joints, drainage, curing and freeze-thaw care to help driveways and patios last in St. Louis winters.

Canonical page: https://midwesthardscapes.com/resources/concrete-maintenance-missouri/

Midwest Hardscapes (Midwest Hardscapes, LLC) is a concrete and hardscape contractor at 4025 Old Hwy 94 S, St. Charles, MO 63304, owned by Bryan Fennell, with over 33 years of experience in concrete. St. Charles concrete and hardscape contractor serving Greater St. Louis: driveways, patios, stamped concrete, pool decks, floors, curbs, outdoor living and commercial concrete, built by craftsmen who start with what goes under the slab. BBB A+ accredited since 2023; 4.8 stars from 31 Google reviews (November 2026). Phone (636) 206-8577.

From Bryan Fennell and the Midwest Hardscapes crew. Updated 2026-11-11.

Concrete maintenance in Missouri comes down to managing water, salt and temperature swings. Concrete is tough, but St. Louis weather tests it every winter. A few simple habits, from sealing to careful de-icing, help driveways, patios and walks last for decades.

## Why Missouri weather is hard on concrete

Water gets into tiny pores and cracks in concrete. When it freezes, it expands and pushes the surface apart. Repeat that through many freeze-thaw cycles and you see flaking, scaling and widening cracks. Salt makes it worse, because it draws moisture in and adds stress when it refreezes.

The St. Louis area sees temperatures cross freezing many times in a typical winter; the National Weather Service St. Louis office publishes local climate data if you want the numbers. Because water is the root cause, almost every maintenance habit below is really about keeping water out or moving it away.

That is also why the work under the slab matters. A compacted base and sound drainage keep water from collecting beneath the concrete, where it can freeze and lift the slab. Maintenance helps, but it works best on a slab that was built right.

## Sealing: how often and why

A good sealer slows water and salt from soaking in. How often you reseal depends on the surface. Stamped concrete should be resealed every 1 to 3 years, depending on sun, traffic and the sealer; reseal when water stops beading. Stamped surfaces and colors show wear sooner. Plain broom-finished slabs usually go longer between coats.

Before sealing, clean the surface and let it dry fully. Choose a sealer made for exterior concrete, and follow the label. If you are not sure which type your slab needs, ask us. Sealing a pool deck or steps may need a slip-resistant additive, so mention that as well.

Apply sealer in thin, even coats rather than one heavy one, and avoid applying it in direct heat or right before rain. A heavy coat can turn cloudy and peel.

## De-icers: what helps and what hurts

Never de-ice new concrete during its first winter, because young concrete is more vulnerable to scaling. Use sand for traction instead, and shovel early. Exterior concrete in Missouri should also be air-entrained: tiny air bubbles in the mix give freezing water room to expand.

For older slabs, the type of product matters. Rock salt (sodium chloride) and calcium chloride are the products industry guidance accepts on well-built, air-entrained concrete, used sparingly. Avoid magnesium chloride and ammonium-based products such as ammonium nitrate or ammonium sulfate, which can attack concrete. Rock salt can also harm nearby plants, so use as little as the job needs. For pavers, use CMA or a similar paver-safe product, as our paver patio guidance notes.

Another practical note: de-icers lose their punch in deep cold. Rock salt stops working well below about 15 degrees Fahrenheit, while calcium chloride keeps working at colder temperatures. Either way, shovel first and use sand for traction. The Portland Cement Association publishes guidance on winter care for concrete.

If a property needs help clearing snow, see our [snow and ice management](https://midwesthardscapes.com/snow-and-ice-management/) service.

> Shovel first, salt second. The less product you put down, the better your concrete holds up.

## Curing new concrete: the first weeks

New concrete reaches its design strength around 28 days. Our driveway guidance is to plan on at least one week before driving on a new driveway. Keep heavy vehicles, deliveries and dumpsters off it longer if you can.

During curing, keep pets, bikes and chairs off the surface until we tell you it is ready, and protect the edges from lawn equipment. Remember: no de-icers on new concrete in its first winter.

## Joints, cracks and drainage

Control joints are planned lines where concrete is meant to crack, rather than cracking randomly. Over time the joint filler can wear. Resealing joints keeps water out of the base, which is where freeze-thaw damage often starts. Watch for small cracks too, since sealing them early is much easier than fixing them later.

Drainage deserves a regular look. Make sure downspouts discharge away from the slab, not onto it. Check that water drains off the surface rather than pooling, and that soil next to the slab has not washed out. If water is standing against your concrete, that is a grading issue worth addressing before winter.

Edges and corners are the first places to show wear. If you see a chip, clean it out and have it looked at before water gets in. Small repairs done early are far less work than a full replacement later.

## Snow shovels, plows and everyday habits

Use a plastic-edged shovel, or set a metal blade just above the surface. Metal edges can chip a slab, especially at joints and edges. Plow damage to curbs and aprons is a common reason for repairs, so mark edges before the season if a plow will be on the property.

Wipe up oil and chemicals from garages and driveways soon after spills. Pressure wash gently and avoid harsh acids unless a professional recommends them. Keep heavy loads, such as a loaded truck or a dumpster, to areas built for them.

## A simple seasonal checklist

Use this list each fall and spring to catch small problems before they grow.

Pick a dry, mild day for each check, and take a few photos. Comparing this year's cracks with last year's tells you quickly whether something is changing.

- Fall: clean the surface, reseal if due, check joints and cracks, and point downspouts away from the slab.
- Winter: shovel early, use sand first, and use de-icers sparingly and never on new concrete in its first winter.
- Spring: rinse off salt residue, look for new cracks or scaling, and note any low spots that hold water.
- Anytime: keep an eye on drainage after heavy rain.

## When maintenance is not enough

Sometimes a slab has a problem that sealing will not solve, such as settling from a poorly compacted base. If repair makes more sense than replacement, we will tell you. If replacement is the honest answer, we will say that too. Bryan is glad to take a look.

A quick note through our contact form is a good place to start. Include a close-up of the problem and a wide shot of the whole slab, and tell us how old it is. That is usually enough to give you a first honest opinion.

Concrete maintenance in Missouri is mostly about keeping water out and being gentle in winter. Seal on schedule, keep joints tight, point downspouts away and go easy on de-icers. If a slab is showing wear and you are not sure whether to repair it or replace it, we will tell you honestly. Our [stamped concrete](https://midwesthardscapes.com/stamped-concrete/) work includes care advice for the finish.

## Frequently asked questions

### How often should I seal my concrete?

It depends on the surface. Stamped concrete should be resealed every 1 to 3 years, depending on sun, traffic and the sealer; reseal when water stops beading. Plain broom-finished slabs can often go longer. Sealing sooner helps in harsh winters or heavy-use areas. If you are unsure, ask us to take a look.

### Can I use salt on a new driveway?

No. Industry guidance is to never de-ice new concrete during its first winter, since it is more vulnerable to scaling. Use sand for traction and shovel early instead. After the first winter, choose products carefully and use as little as you can.

### Is rock salt bad for concrete?

Not on well-built concrete, used sparingly. Rock salt (sodium chloride) and calcium chloride are the de-icers industry guidance accepts on air-entrained concrete. Avoid magnesium chloride and ammonium nitrate or sulfate, and never de-ice new concrete in its first winter. Rock salt can harm nearby plants, and pavers call for a paver-safe product. Shoveling first reduces how much you need.

### How long should new concrete cure before I drive on it?

Plan on at least one week before driving on a new driveway, based on our driveway guidance. Concrete reaches its design strength around 28 days, so keep heavy loads off for longer if you can. Ask us about your specific pour and the weather.

### What causes concrete to flake or scale in Missouri winters?

Usually water and freeze-thaw cycles, often made worse by de-icing salts. Water enters the surface, freezes and pushes off the top layer. Sealing, good drainage and careful de-icer use all lower the risk, especially in the first few winters. Early repair of small flaking spots helps.

### Do I need to seal the joints in my concrete?

Yes, joint sealing is a smart habit. Control joints are planned crack lines, and filler can wear over time. Keeping joints sealed keeps water out of the base, where freeze-thaw damage often begins. Check them each fall and spring, and reseal as needed.

## Contact

- Midwest Hardscapes, 4025 Old Hwy 94 S, St. Charles, MO 63304
- Phone: (636) 206-8577
- Free estimate: https://midwesthardscapes.com/contact-us/
